Wall2Floor Top Coat

Decorative coating for horizontal and vertical surfaces

Wall2Floor Top Coat is a mineral plaster coat for the decoration of horizontal and vertical surfaces in prestigious places.

Wall2Floor Uses

Wall2Floor can be applied on:

Concrete
Screeds (sand and cement-based screeds, sand and specific binder for screeds, ready-made packaged screeds, self-leveling sand and cement screeds)
Radiant and refreshing screeds with minimum thickness, above pipe, between 30-40 mm
Surfaces covered with ceramic, porcelain and mosaic tiling
Klinker
Surfaces with existing epoxy or polyurethane coatings
Surfaces in natural and rebuilt stone
Mineral conglomerates of various kinds, provided they are absorbent
New and old plasters based on hydraulic binders
Organic or mineral decorative coatings

Wall2Floor Unsuitable Substrates

The Wall2Floor system cannot be applied to forkliftable surfaces, horizontal or vertical substrates that do not offer the necessary guarantees in terms of bonding and dimensional stability.

Forkliftable surfaces (garages, loading-unloading areas where the use of trolleys, transpallets, forklifts or similar, cars, etc.)
Radiant screeds with heating and cooling system
Wooden flooring
Linoleum
Pre-finished wooden flooring
Painted and unpainted uperfici metal surfaces
Glass surfaces or concrete and glass blocks
Moist surfaces or surfaces with rising damp
Do not apply to bathroom fittings or other substrates where water may be collected
In case of radiant screeds with electric heating system, Calcium sulphate CA or magnesite MA, other types, please contact our technical assistance service.

Application:

Mixing ratio by weight: 15 Kg of Wall2Floor Top Coat + 5 Kg of Wall2Floor Component B.
Dilution: it is possible to dilute the final mix by adding up to 5% of water.
Tinting: stir Wall2Floor Top Coat before colouring. Tint using Novacolor tinting system. Mix the colouring agent with Wall2Floor Top Coat using a gyroscopic stirrer or a mechanical spiral stirrer.
Preparing the mix: only immediately before applying the product at the job site add to each 15 kg package of Wall2Floor Top Coat, a 5 kg package of Wall2Floor Component B. The powder component (Wall2Floor Component B) must be added gradually and blending performed using a mechanical spiral stirrer. The mixing of the two components cannot be performed manually.
Mixing time: about three minutes to a uniform mix. The mix obtained must be a uniform, thixotropic mortar free of lumps.
Pot life of mix: approx. 120 minutes
Application equipment: stainless steel trowel.
Application: apply a first coat of Wall2Floor Top Coat, previously mixed with Wall2Floor Component B to smooth the surface. Wait for the surface to dry, usually between 3-4 hours, and then apply a second layer of Wall2Floor Top Coat, previously mixed with Wall2Floor Component B, and work the surface to obtain the desired aesthetic effect.
No. of coats: 2
Coverage rate (referred to the mix Wall2Floor Top Coat + Wall2Floor Component B): 1.2-1.5 kg/m², on the two coats.
Drying time: touch dry after approx. 3-4 hours; over painting possible after 12-14 hours

May also be applied over:

Decoration of highly valuable interiors in compliance with current trends in fashion and architecture.

Approximate coverage yields 1.2-1.5 kg/m², in two layers depending on the application technique and the substrate condition. It is advisable to check the yield with a test on the specific support.