Wall2Floor Sealer Hydro-Oleo Repellent

Hydro-oleo repellent to restore indoor surfaces in Wall2Floor

Wall2Floor Sealer hydro-oleo repellent is a protective coat/sealant against water for indoors, which creates a non-film forming barrier against the passage of water and various oily substances, without considerably altering the appearance of the surface.

Wall2Floor Sealer hydro-oleo repellent is composed of a mix of fluorocarbon-based polymers and rheological additives for the restoration of indoor surfaces of the Wall2Floor systems.

Wall2Floor Sealer hydro-oleo repellent can be applied to restore the surface protection from dirt and scratches deriving from everyday use following wear of the protective film

Wall2Floor Uses

Wall2Floor can be applied on:

Concrete
Screeds (sand and cement-based screeds, sand and specific binder for screeds, ready-made packaged screeds, self-leveling sand and cement screeds)
Radiant and refreshing screeds with minimum thickness, above pipe, between 30-40 mm
Surfaces covered with ceramic, porcelain and mosaic tiling
Klinker
Surfaces with existing epoxy or polyurethane coatings
Surfaces in natural and rebuilt stone
Mineral conglomerates of various kinds, provided they are absorbent
New and old plasters based on hydraulic binders
Organic or mineral decorative coatings

Wall2Floor Unsuitable Substrates

The Wall2Floor system cannot be applied to forkliftable surfaces, horizontal or vertical substrates that do not offer the necessary guarantees in terms of bonding and dimensional stability.

Forkliftable surfaces (garages, loading-unloading areas where the use of trolleys, transpallets, forklifts or similar, cars, etc.)
Radiant screeds with heating and cooling system
Wooden flooring
Linoleum
Pre-finished wooden flooring
Painted and unpainted uperfici metal surfaces
Glass surfaces or concrete and glass blocks
Moist surfaces or surfaces with rising damp
Do not apply to bathroom fittings or other substrates where water may be collected
In case of radiant screeds with electric heating system, Calcium sulphate CA or magnesite MA, other types, please contact our technical assistance service.

Application:

On the clean and dry substrate, distribute excess Wall2Floor hydro-oleo repellent with a wax applicator or cloth.
Wait a few minutes to allow the product to penetrate the surface and remove any excess.
As necessary, application is possible of a second wet on wet coat, following the previously described methods.

May also be applied over:

Applicable on horizontal and vertical indoor surfaces, coated with Wall2Floor system.

Wall2Floor Sealer hydro-oleo repellent must be applied as a last coat, over at least two coats of one of the Clear Finish protective finishes (Glossy, Satin, Matt, Countertop, Countertop Ultra Matt).

Approximate coverage yields 4-8 m²/l per single coat, based on the type of substrate and its absorption rate. It is advisable to determine the real yield with a preliminary test on the specific substrate.