Two-component epoxy primer for indoor mineral finishes
Mineral Sealer is a new-generation, two-component, epoxy primer, with low emissions of volatile organic compounds and low emissions of formaldehyde.
It can be diluted in water, with low viscosity and high penetrating power. Specifically for indoor, vertical and horizontal mineral finishes.
Mineral Sealer does not alter the colors of decorative finishes and maintains unchanged the troweled effect.
Mineral Sealer can be used as sealer in Wall2Floor systems, when combined with Wall2Floor Top Coat Fine.
Mineral Sealer consolidates the mineral surface and optimises application technical performance of Clear Finish during the laying phase and subsequent hardening phase.
Application:
- The surface must be completely dry, dust-free and free of salt stains caused by humidity.
- Using a brush, apply a coat of previously mixed and diluted Mineral Sealer, taking care to saturate the pores of the substrate and distribute the product evenly over the entire surface.
- The surface treated with Mineral Sealer must always be covered by one of the Clear Finish finishes.
May also be applied over:
Specifically for the preparation of indoor, vertical mineral surfaces:
- Decorative finishes in mineral nature
- Stone, limestone, marble, natural stone or cast stone materials
- Exposed brick
- Concrete surfaces
It is not suitable for film-forming protection of Era Veneziana, Mirror and Extrawhite, Archi+ Concrete and Big.
Approximate coverage yields 4-8 m2/l for each layer on irregular substrates; 8-12 m2/l for each layer on smooth substrates.
It is advisable to determine the real yield with a preliminary test on the specific substrate.
