Wall2Floor Primer

High penetrating bicomponent primer

Wall2Floor Primer is an epoxy bi-component primer, epoxy resin-based, with high penetrating powers specific for the “Wall2Floor System”.

Wall2Floor Primer reinforces the mineral surface of the Wall2Floor Top Coat and optimizes the product performances of the Wall2Floor Clear Finish during the application and hardening phases.

Wall2Floor Uses

Wall2Floor can be applied on:

Concrete
Screeds (sand and cement-based screeds, sand and specific binder for screeds, ready-made packaged screeds, self-leveling sand and cement screeds)
Radiant and refreshing screeds with minimum thickness, above pipe, between 30-40 mm
Surfaces covered with ceramic, porcelain and mosaic tiling
Klinker
Surfaces with existing epoxy or polyurethane coatings
Surfaces in natural and rebuilt stone
Mineral conglomerates of various kinds, provided they are absorbent
New and old plasters based on hydraulic binders
Organic or mineral decorative coatings

Wall2Floor Unsuitable Substrates

The Wall2Floor system cannot be applied to forkliftable surfaces, horizontal or vertical substrates that do not offer the necessary guarantees in terms of bonding and dimensional stability.

Forkliftable surfaces (garages, loading-unloading areas where the use of trolleys, transpallets, forklifts or similar, cars, etc.)
Radiant screeds with heating and cooling system
Wooden flooring
Linoleum
Pre-finished wooden flooring
Painted and unpainted uperfici metal surfaces
Glass surfaces or concrete and glass blocks
Moist surfaces or surfaces with rising damp
Do not apply to bathroom fittings or other substrates where water may be collected
In case of radiant screeds with electric heating system, Calcium sulphate CA or magnesite MA, other types, please contact our technical assistance service.

Application:

Mixing ratio by weight: 2 parts of component A + 1 part of component B.
Preparing the mix: stir Wall2Floor Primer Component A to incorporate any sediment. Pour Wall2Floor Primer Component B into Wall2Floor Primer Component A and mix by hand for approx. 45-60 seconds.
Dilution: dilute the final mix (0,500 l of component A + 0,250 l of component B) by adding 3 l of water. Application equipment: brush.
Pot life of mix: approx. 60 minutes
Application: apply a coat of Wall2Floor Primer prepared in advance. Spread the product evenly and smoothly over the entire surface, ensuring saturation according to substrate porosity, using a sponge trowel. Throughout each stage of finishing, do not wait more than 72 hours before applying a coat over the preceding layer.
No. of coats: 1
Coverage rate (referred to A+B mix): 16-21 m²/l, a layer.
Drying time: touch dry after approx. 3 hours; over painting possible after 12 hours.