Wall2Floor Epoxy Binder

Epoxy bi-component for Wall2Floor Rasal

Wall2Floor Epoxy Binder is a bi-component epoxy binder.

Wall2Floor Epoxy Binder mixed with Wall2Floor Rasal allows the creation of an epoxy-cement, tri-component levelling agent, specific for the “Wall2Floor System”.

Wall2Floor Uses

Wall2Floor can be applied on:

Concrete
Screeds (sand and cement-based screeds, sand and specific binder for screeds, ready-made packaged screeds, self-leveling sand and cement screeds)
Radiant and refreshing screeds with minimum thickness, above pipe, between 30-40 mm
Surfaces covered with ceramic, porcelain and mosaic tiling
Klinker
Surfaces with existing epoxy or polyurethane coatings
Surfaces in natural and rebuilt stone
Mineral conglomerates of various kinds, provided they are absorbent
New and old plasters based on hydraulic binders
Organic or mineral decorative coatings

Wall2Floor Unsuitable Substrates

The Wall2Floor system cannot be applied to forkliftable surfaces, horizontal or vertical substrates that do not offer the necessary guarantees in terms of bonding and dimensional stability.

Forkliftable surfaces (garages, loading-unloading areas where the use of trolleys, transpallets, forklifts or similar, cars, etc.)
Radiant screeds with heating and cooling system
Wooden flooring
Linoleum
Pre-finished wooden flooring
Painted and unpainted uperfici metal surfaces
Glass surfaces or concrete and glass blocks
Moist surfaces or surfaces with rising damp
Do not apply to bathroom fittings or other substrates where water may be collected
In case of radiant screeds with electric heating system, Calcium sulphate CA or magnesite MA, other types, please contact our technical assistance service.

Application:

Wall2Floor Epoxy Binder Component A and B + Wall2Floor Rasal: three-component epoxy-cementitious skim coat

Mixing ratio by weight: 2 parts of Wall2Floor Epoxy Binder Component A (1.6 l) + 1 part Wall2Floor Epoxy Binder Component B (0.8 l) + 25 Kg of Wall2Floor Rasal.
Dilution: the final mix (1.6 l of component A + 0.8 l of component B) must be diluted by adding 3-3.5 l of water.
Preparing the mix: stir Wall2Floor Epoxy Binder Component A to incorporate any sediment. Pour Wall2Floor Epoxy Binder Component B into Wall2Floor Epoxy Binder Component A and mix for approx. 45-60 seconds. Add Wall2Floor Rasal gradually to the obtained mix while stirring continuously. Use a mechanical spiral stirrer to blend the mix; this operation cannot be performed manually.
Mixing time: about three minutes to a uniform mix. The mix obtained must be a uniform, thixotropic mortar free of lumps. Periodically blend the mix to prevent the stratification of inert matter.
Pot life of mix: approx. 30 minutes
Application equipment: notched trowel and stainless steel trowel.
Application: apply Wall2Floor Epoxy Binder Component A and B + Wall2Floor Rasal evenly on the surface.
No. of coats: 1
Coverage rate (referred to A+B mix + Wall2Floor Rasal): 3.0 Kg/m² in two layers
Drying time for thicknesses up to 3 mm: touch dry after approx. 3-4 hours; over painting possible after 4 hours.